Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

On vehicles coated with Hard Clear Coat, use double-faced 3M adhesive tape Product No. 4210 or equivalent, after priming with 3M primer Product No. N200 or C-100 or equivalent.
The repair parts are also affixed with double-faced adhesive tape.
To re-use existing molding, clean all traces of double sided tape from the molding and apply new double-faced tape to the molding.

Clean the panel surface with isopropyl alcohol or equivalent to degrease the surface.
Heat the panel and molding tape surface to 30° to 40°C (86° to 104°F).
Remove the backing sheet from the tape surface.
Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press molding to door surface.
CAUTION: To secure contact, do not wash vehicle for 24 hours after installation.
Install slide door rail cover in the reverse order of removal.
NOTE: Always discard clips and replace with new clips.
Install door sash cover in the reverse order of removal.