Removal and Installation: Installation
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal. Note the following:
CAUTION:
Be sure to replace the differential side oil seal with a new one every time drive shaft is removed on 4 A/T models. Refer to
"Differential Side Oil Seal Replacement".
- Refer to
"REMOVAL AND INSTALLATION " for tightening torques.CAUTION: Do not reuse non-reusable parts.
- When installing wheel hub and bearing assembly to steering knuckle, align cutout in toner ring cover with ABS sensor mounting hole in steering knuckle.
- When installing disc rotor on wheel hub and bearing assembly, align the marks.
(When not using the alignment mark, refer to "DISC ROTOR INSPECTION ".)