Removal Of Liquid Gasket Sealing

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

After removing the bolts and nuts, separate the mating surface and remove the sealant using Tool.
- Tool number: KV10111100 (J-37228)
Fig 1: Removing Sealant From Mating Surface Using Tool (J-37228)
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Be careful not to damage the mating surfaces.
In areas where the Tool is difficult to use, use a plastic hammer to lightly tap the areas where the sealant is applied.
CAUTION: If for some unavoidable reason a tool such as a flat-bladed screwdriver is used, be careful not to damage the mating surfaces.