Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Tighten the transverse link mounting bolts to specified torque. Refer to "COMPONENTS ". During installation, the final tightening must be done with the vehicle at curb weight and the tires on the ground.
CAUTION: Discard the old cotter pin and use a new cotter pin for installation of the lower ball joint nut.
After installation, check the wheel alignment. Refer to "FRONT WHEEL ALIGNMENT ".