LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1493 (Manual Air Conditioner) >> Heater & Cooling Unit Assembly >> Removal and Installation >> Front Heater And Cooling Unit Assembly >> Removal

Front Heater And Cooling Unit Assembly: Removal

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge the refrigerant from the A/C system. Refer to "DISCHARGING REFRIGERANT ".
  2. Drain the coolant from the engine cooling system. Refer to "DRAINING ENGINE COOLANT ".
  3. Remove the cowl top extension. Refer to "COWL TOP ".
  4. Remove the exhaust system. Refer to "REMOVAL AND INSTALLATION ".
  5. Disconnect the front heater hoses from the front heater core.
  6. Disconnect the high/low pressure pipe from the front expansion valve.
  7. Move the two front seats to the rearmost position on the seat track.
  8. Remove the instrument panel and console panel. Refer to "REMOVAL AND INSTALLATION ".
  9. Remove the steering column. Refer to "REMOVAL AND INSTALLATION ".
  10. Disconnect the instrument panel wire harness at the RH and LH in-line connector brackets, and the fuse block (J/B) electrical connectors. Refer to "HARNESS LAYOUT ".
  11. Disconnect the steering member from each side of the vehicle body.
  12. Remove the front heater and cooling unit assembly with it attached to the steering member, from the vehicle.
    CAUTION: Use care not to damage the seats and interior trim panels when removing the front heater and cooling unit assembly with it attached to the steering member.
  13. Remove the front heater and cooling unit assembly from the steering member.
scientia non olet · About LEMON Manuals