LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1271 (Brake Control System) >> VDC/TCS/Abs >> Actuator And Electric Unit (Assembly) >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery cable.
  2. Remove windshield wiper and linkage assembly. Refer to REMOVAL AND INSTALLATION FOR WIPER MOTOR AND .
  3. Drain brake fluid.
  4. Discharge the A/C refrigerant. Refer to REFRIGERATION SYSTEM . .
  5. Disconnect and remove high-pressure and low-pressure A/C pipes to allow access to ABS actuator and electric unit (control unit). Refer to COMPONENT LAYOUT .
  6. Disconnect harness connectors from ABS actuator and electric unit (control unit).
  7. Disconnect brake pipes.
  8. Remove fasteners for ABS actuator and electric unit (control unit) and remove from vehicle.
scientia non olet · About LEMON Manuals