High Beam Operation/Flash-to-pass Operation

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

When the lighting switch is moved to headlamp "ON" (2ND) position, "HIGH BEAM" (A) or "FLASH TO PASS" (C) position, power is supplied:

from lighting switch terminal 6
to RH headlamp terminal HI, and
from lighting switch terminal 9
to daytime light control unit terminal 5, and
to combination meter terminal 2 (with tachometer), 12 (without tachometer) for the high beam indicator
through daytime light control unit terminal 6
to LH headlamp terminal HI.

Ground is supplied in the same manner as low beam operation.

Ground is supplied to terminal 3 (with tachometer), 14 (without tachometer) of the combination meter through body grounds M28 and M54.

With power and ground supplied, the high beam headlamps and high beam indicator illuminate.