Removal and Installation
WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Wrap the tip of a flat-bladed screwdriver with cloth when prying pawls from door trim.
- Remove the door pull finisher(s).
- Remove power window switch(es) finisher(s), then disconnect the connector(s) (models equipped with power windows).
- Do not lift the front of the power window switch assembly.
- Remove window regulator handle (models without power windows).
- Remove screws and disconnect clips C101 and clips C103 from door.
- Reach behind and carefully pull door trim panel from inside handle until finisher pops off.
- Lift out door trim.