Consult-II Inspection Procedure

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.

Fig 1: Identifying Pedal
Courtesy of NISSAN MOTOR CO., U.S.A.
Connect "CONSULT-II" to data link connector.
Insert NVIS (NATS) program card into CONSULT-II.
Program card : NATS (AEN02C)

Fig 2: Identifying Scan Tool Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Touch "START".
Select "NATS V.5.0".

Fig 3: Display Turn Ignition Switch On
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic test mode according to each service procedure.

Fig 4: Diagnostic Test Mode According To Each Service
Courtesy of NISSAN MOTOR CO., U.S.A.

For further information, see the "CONSULT-II OPERATION MANUAL IVIS/NVIS".