LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1174 (Automatic Transaxle - Re4F03B) >> DTC Batt/Fluid Temp Sen (A/T Fluid Temp Sensor Circuit And TCM Power Source) >> DTC U1000 Can Communication Line >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to ON position. (Do not start engine.)
  2. Select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
  3. Start engine and wait for at least 6 seconds.
  4. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: Consult II Display
    G00899564Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals