Clutch Master Cylinder: Installation
WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
- Install the reservoir hose.
- Connect the clutch tube to the master cylinder assembly, and hand-tighten the flare nut.
- Install the master cylinder assembly to the cowl, and tighten the nuts to specification.
Master cylinder nuts: 10.8 -14.6 N-m (1.1 -1.4 kg-m, 8-10 ft-lb)
- Tighten reservoir tank bracket nuts to specification.
Reservoir tank bracket nuts: 2.9 - 5.9 N-m (0.29 - 0.60 kg-m, 26 - 52 in-lb)
- Tighten clutch tube flare nut using a flare nut torque wrench to specification.
Clutch tube flare nut: 15 -18 N-m (1.5 -1.8 kg-m, 11-13 ft-lb)
- After installing the clevis pin, install the snap pin to connect the clutch pedal to the push rod.
- After finishing the installation, bleed the air out of the clutch hydraulic system. Refer to . "BLEEDING PROCEDURE ".