With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Start engine and warm it up to normal operating temperature.
Select "A/F SEN1 (B1) P1274" of "A/F SEN1" in "DTC WORK SUPPORT" mode.
Touch "START".
Maintain the following conditions continuously until "TESTING" changes to "COMPLETED". (It will take approximately 400 to 800 seconds.)
NOTE: Keep the accelerator pedal as steady as possible.

Fig 1: Specifications Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Displaying OUT OF CONDITION With Consult-II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.

If "TESTING" is not displayed after 20 minutes, retry from step 2.

Fig 3: Displaying TESTING With Consult-II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure that "OK" is displayed after touching "SELF-DIAG RESULTS".
If "NG" is displayed, go to "DIAGNOSTIC PROCEDURE ".

Fig 4: Displaying COMPLETED With Consult-II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.