LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1165 (Engine Control System - Qr25DE) >> DTC P0447: EVAP Canister Vent Control Valve >> Component Inspection >> EVAP Canister Vent Control Valve >> Without CONSULT-II

Without CONSULT-II

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove EVAP canister vent control valve from EVAP canister.
  2. Check portion B of EVAP canister vent control valve for being rusted.
    Fig 1: Inspecting EVAP Canister Vent Control Valve
    G00777978Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Check air passage continuity and operation delay time under the following conditions.

    Make sure new O-ring is installed properly. 

    Fig 2: Checking Air Passage Continuity & Operation Delay Time
    G00777980Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 3: EVAP Canister Vent Control Valve Condition Chart
    G00777979Courtesy of NISSAN MOTOR CO., U.S.A.

    Operation takes less than 1 second. 

    If NG, replace EVAP canister vent control valve.

    If OK, GO TO next step.

  4. Clean the air passage (Portion A to B) of EVAP canister vent control valve using an air blower.
  5. Perform step 3 again.