LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1165 (Engine Control System - Qr25DE) >> DTC P0125: ECT Sensor >> Diagnostic Trouble Code (DTC) Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Check that "COOLAN TEMP/S" is above 15°C (59°F).

    If it is above 15°C (59°F), the test result will be OK. If it is below 15°C (59°F), go to following step. 

  4. Start engine and run it for 65 minutes at idle speed.

    If "COOLAN TEMP/S" increases to more than 15°C (59°F) within 65 minutes, stop engine because the test result will be OK. 

  5. Fig 1: Selecting Data Monitor Mode With Consult-II
    G00776982Courtesy of NISSAN MOTOR CO., U.S.A.
  6. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".