Procedure For Malfunction B

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

With CONSULT-II

Turn ignition switch ON and wait at least 1 second.
Select "DATA MONITOR" mode with CONSULT-II.
Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .

Fig 1: Displaying DATA MONITOR Mode (2 Of 3)
Courtesy of NISSAN MOTOR CO., U.S.A.

With GST

Follow the procedure "With CONSULT-II" above.