DTC Confirmation Test (Using Generic Scan Tool)
WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the following test to check overall function of EVAP-CVCV circuit. During this test, DTC may not be confirmed.
- Disconnect hose from water separator. See Figure. Disconnect EVAP-CVCV 2-pin harness connector. Using jumper wires, apply battery voltage to EVAP-CVCV terminals. See Figure. With voltage applied, air should not flow through EVAP-CVCV. Remove jumper wires. Air should flow.
- If operation is not as specified, go to DIAGNOSTIC PROCEDURE . If operation is as specified, perform DIAGNOSTIC PROCEDURE for DTC P0442 .