DTC Confirmation Test
WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing. Ensure battery voltage at idle is more than 10 volts.
Turn ignition on. Select DATA MONITOR mode with scan tool. Start engine and allow to idle for at least 10 seconds. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.