LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Engine Controls Self-Diagnostics - Pathfinder) >> Diagnostic Tests >> DTC P0506: Idle Speed Control System - Idle Lower Than Expected >> DTC Confirmation Test

DTC Confirmation Test

WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If target idle speed is not 700-800 RPM (no load in Park) or more than 825 RPM (A/C on in Park), perform idle air volume learning procedure before proceeding. See IDLE AIR VOLUME LEARNING  under PROGRAMMING.
NOTE: Before proceeding, ensure battery voltage is more than 11 volts with ignition on. If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing. Before proceeding, ensure battery voltage is more than 11 volts at idle and ambient temperature is more than 14°F (-10°C).
  1. Open hood. Start engine and warm to normal operating temperature.
  2. Turn ignition off and wait at least 10 seconds. Turn ignition on. Select DATA MONITOR mode on CONSULT-II or generic scan tool.
  3. Start engine let it idle for at least one minute. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.