LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Engine Controls Self-Diagnostics - Pathfinder) >> Diagnostic Tests >> DTC P0500: Vehicle Speed Sensor >> DTC Confirmation Test (Using CONSULT-II)

DTC Confirmation Test (Using CONSULT-II)

WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing.
NOTE: DTC confirmation may be conducted while test driving vehicle or with wheel lifted off of ground.
  1. Start engine. Read VHCL SPEED SE in DATA MONITOR mode with CONSULT-II. VHCL SPEED SE should be able to exceed 6 MPH when drive wheels are rotating at 6 MPH or more. If operation is as specified, go to next step. If operation is not as specified, go to DIAGNOSTIC PROCEDURE .
  2. Select DATA MONITOR mode with CONSULT-II. Warm engine to normal operating temperature. Maintain following conditions for at least 10 consecutive seconds:
    • ENG SPEED: more than 1800 RPM.
    • COOLAN TEMP/S: more than 158°F (70°C).
    • B/FUEL SCHDL: more than 5.5 msec
    • PW/ST SIGNAL: OFF
  3. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals