DTC Confirmation Test (Using CONSULT-II)
WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing.
- Start engine and warm to operating temperature. Turn ignition off. Wait at least 10 seconds.
- Start engine. Allow engine to idle for 6 seconds. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.