LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0127: Intake Air Temperature Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wait until engine coolant temperature is less than 194°F (90°C).
    • Turn ignition switch ON.
    • Select "DATA MONITOR" mode.
    • Check the engine coolant temperature.
    • If the engine coolant temperature is not less than 194°F (90°C), turn ignition switch OFF and cool down engine.
    Perform the listed steps before engine coolant temperature is above 194°F (90°C).
  2. Turn ignition switch ON.
  3. Select "DATA MONITOR" mode.
  4. Start engine.
  5. Hold vehicle speed at more than 43 MPH (70 km/h) for 100 consecutive seconds.
  6. If 1st trip DTC is detected, see DIAGNOSTIC PROCEDURE (2.5L)  or DIAGNOSTIC PROCEDURE (3.5L)  .