DTC Confirmation Procedure (With GST)
WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When using GST, DTC confirmation procedure should be performed twice as much as when using CONSULT-II because GST cannot display "MODE 7" (1st trip DTC) concerning this diagnosis. Therefore, using CONSULT-II is recommended.
- Start engine and warm to normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and keep engine speed between 3500-4000 RPM for at least 1 minute under no load.
- Let engine idle for 1 minute.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and keep engine speed between 3500-4000 RPM for at least 1 minute under no load.
- Let engine idle for 1 minute.
- Select "MODE 3" with GST.
- If DTC is detected, see DIAGNOSTIC PROCEDURE (2.5L) or DIAGNOSTIC PROCEDURE (3.5L) .