Daytime Light Control Unit Inspection Table
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
DAYTIME LIGHT CONTROL INSPECTION CHART
| Terminal No. | Wire color | Item | Condition | Voltage (Approx.) |
|---|---|---|---|---|
| 1 | BR/W | Ignition switch start signal | Ignition switch in START position | 12 |
| All other conditions | 0 | |||
| 2 | SB | Battery | Ignition switch in all positions | 12 |
| 3 | SB | Battery | Ignition switch in all positions | 12 |
| 4 | L | Lighting switch headlamp LH low beam output | Lighting switch in the headlamp ON (2ND) position and low beam (B) position | 12 |
| All other conditions | 0 | |||
| 5 | G | Lighting switch headlamp RH high beam output | Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position | 12 |
| All other conditions | 0 | |||
| 6 | L/W | Headlamp LH high beam | Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position | 12 |
| With parking brake released, engine running and lighting switch in OFF or parking and tail lamp ON (1ST) positions
CAUTION:
Block wheels and ensure selector lever is in P or N position.
|
12 | |||
| All other conditions | 0 | |||
| 7 | Y/G | Headlamp LH control | Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position and high beam position | 0 |
| With parking brake released, engine running and lighting switch in OFF or parking and tail lamp ON (1 ST) positions
CAUTION:
Block wheels and ensure selector lever is in P or N position
|
12 | |||
| All other conditions | 0 | |||
| 8 | Y | Lighting switch headlamp RH high beam output | Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position | 12 |
| With parking brake released, engine running and lighting switch in OFF or parking and tail lamp ON (1 ST) positions
CAUTION:
Block wheels and ensure selector lever is in P or N position
|
6 | |||
| All other conditions | 0 | |||
| 9 | B | Ground | - | - |
| 10 | Y/G | Parking brake switch | Parking brake released | 12 |
| Parking brake set | 0 | |||
| 11 | BR/Y | Generator | When engine is running | 12 |
| (L terminal) | All other conditions | 0 | ||
| 12 | G | Ignition switch on signal | Ignition switch OFF, ACC positions | 0 |
| Ignition switch ON, START positions | 12 |