LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Automatic HVAC System) >> Refrigerant Lines >> Removal and Installation for Compressor >> Removal

Removal and Installation for Compressor: Removal

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge the refrigerant. Refer to "HFC-134A (R-134A) SERVICE PROCEDURE ".
  2. Remove the engine under cover and the splash shield.
  3. Remove the drive belt.
  4. Remove the compressor mounting stud.
  5. Disconnect the compressor connector.
  6. Disconnect the high-pressure flexible hose and low-pressure flexible hose from the compressor.
    CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
  7. Remove the compressor bolts and nut using power tools.
scientia non olet · About LEMON Manuals