LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Automatic HVAC System) >> Heater Pump >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms and blades. Refer to REMOVAL AND INSTALLATION FOR FRONT WIPER ARMS .
  2. Remove the cowl top. Refer to "COWL TOP ".
  3. Partially drain the engine cooling system.
  4. Remove the two heater pump clips securing the heater pump to the cowl top extension.
  5. Disconnect the heater pump electrical connector and the two heater hoses, then remove the heater pump.
    CAUTION: Do not disassemble the heater pump, replace the heater pump as an assembly.
    Fig 1: Identifying Heater Pump Clips
    G00866880Courtesy of NISSAN MOTOR CO., U.S.A.