Removal and Installation: Installation

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

On vehicles coated with Hard Clear Coat, use double-faced 3M adhesive tape Product No. 4210 or equivalent, after priming with 3M primer Product No. N200 or C-100 or equivalent.
The repair parts are also affixed with double-faced adhesive tape.
To re-use existing molding, clean all traces of double sided tape from the molding and apply new double-faced tape to the molding.

Clean the panel surface with isopropyl alcohol or equivalent to degrease the surface.
Heat the panel and molding tape surface to 30° to 40°C (86° to 104°F).
Remove the backing sheet from the tape surface.
Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press molding to door surface.
CAUTION: To secure contact, do not wash vehicle for 24 hours after installation.
Install slide door rail cover in the reverse order of removal.
Install door sash cover in the reverse order of removal.