Gap Adjustment
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If any gap or height difference between glass lid and roof is found, check glass lid fit and adjust as follows:
- Open sunshade assembly.
- Loosen glass lid securing screws (2 each on left and right sides), then tilt glass lid down.
- Manually adjust glass lid from outside of vehicle so it resembles "A-A" as shown in the figure above.
- After adjusting glass lid tilt glass lid up and tighten screws.
- Tilt glass lid up and down several times to check that it moves smoothly.