Abs Warning Lamp, Slip Indicator Lamp And TCS Off Indicator Lamp Inspection
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure ABS warning lamp, SLIP indicator lamp and TCS OFF indicator lamp (when TCS OFF switch is off), turn on for approximately 1 second when the ignition switch is turned ON. If they do not, check the TCS OFF indicator lamp and the TCS OFF switch. Check CAN communications. If there are no errors with the TCS OFF switch or the CAN communication system, check combination meter. Refer to COMBINATION METERS .
- Make sure the lamps turn off approximately 1 second after the ignition switch is turned ON. If the lamp does not turn off, conduct self-diagnosis.
- With the engine running, make sure the TCS OFF indicator lamp turns on and off when the TCS OFF switch is turned on and off. If the indicator lamp status does not correspond to switch operation, check the TCS OFF switch. Refer to "TCS OFF SWITCH ".
- Make sure ABS warning lamp, SLIP indicator lamp and TCS OFF indicator lamp turn off approximately 2 seconds after the engine is started. If ABS warning lamp, SLIP indicator lamp or TCS OFF indicator lamp have not turned off 10 seconds after the engine has been started, conduct self-diagnosis of the ABS actuator and electric unit (control unit).
- After conducting the self-diagnosis, be sure to erase the error memory. Refer to "CONSULT-II FUNCTION ".