Unexpected Pedal Action
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK WARNING LAMP ACTIVATION
Make sure warning lamp remains off while driving.
OK or NG
- OK: GO TO 2.
- NG: Carry out self-diagnosis. Refer to "SELF-DIAGNOSIS ".
- CHECK BRAKE PEDAL STROKE
Check brake pedal stroke.
Is pedal stroke excessive?
- Yes: Perform Basic Inspection. Refer to "BASIC INSPECTION ".
- No: GO TO 3.
- CHECK CONNECTOR AND BRAKING PERFORMANCE
- Disable ABS by disconnecting ABS actuator and electric unit (control unit) connector.
- Drive vehicle and check brake operation.
NOTE: Stopping distance may be longer than vehicles without ABS when road condition is slippery.OK or NG
- OK: GO TO 4.
- NG: Perform Basic Inspection. Refer to "BASIC INSPECTION ".
- CHECK WHEEL SENSORS
Check the following.
- Wheel sensor mounting for looseness
- Wheel sensors for physical damage
- Wheel sensor connectors for terminal damage or loose connections
OK or NG
- OK: Check ABS actuator and electric unit (control unit) connector terminals for deformation, disconnection, looseness or damage. Reconnect ABS actuator and electric unit (control unit) harness connector. Then retest.
- NG: Repair or replace as necessary.