Removal and Installation: Removal
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery terminal.
- Remove the cowl top extension. Refer to COWL TOP .
- Drain the brake fluid. Refer to BLEEDING BRAKE SYSTEM .
- Disconnect the actuator harness from the ABS actuator and electric unit (control unit).CAUTION:
- To remove the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged.
- Be careful not to splash brake fluid on painted areas.
- Disconnect the brake tubes.
- Remove the three bolts and remove the ABS actuator and electric unit (control unit).