LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1059 (Brake Control System) >> TCS/Abs >> Actuator And Electric Unit (Assembly) >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION: To install, use a flare nut wrench (commercial service tool).
  1. Always tighten the brake tubes to the specified torque when installing.
  2. Never reuse drained brake fluid.
  3. After installation of the ABS actuator and electric unit (control unit), refill the brake system with new brake fluid. Then bleed the air from the system. Refer to BLEEDING BRAKE SYSTEM .
scientia non olet · About LEMON Manuals