LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1058 (Tires, Wheels & Tire Pressure Monitoring System (TPMS)) >> Trouble Diagnoses >> ID Registration Procedure >> Id Registration Without Transmitter Activation Tool

Id Registration Without Transmitter Activation Tool

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

This procedure must be done after replacement of a low tire pressure warning transmitter, BCM, or tire rotation. 

  1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.
  2. Select "START (NISSAN BASED VHCL)".
  3. Touch "BCM" on "SELECT SYSTEM" screen.
    NOTE: If "BCM" is not indicated, go to "CAN COMMUNICATION ".
  4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
  5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
  6. Adjust the tire pressure to the values shown in the table below for ID registration, and drive the vehicle at 15 km/h (9.4 MPH) or more for a few minutes.
    TIRE PRESSURE SPECIFICATION

    Tire position Tire pressure kPa (kg/cm2 , psi)
    Front - Left 250 (2.5, 36)
    Front - Right 230 (2.3, 33)
    Rear - Right 210 (2.1,30)
    Rear - Left 190(1.9,27)
  7. After completing all ID registrations, press "END" to complete the procedure.
    TIRE POSITION ACTIVATION REFERENCE

    Activation tire position CONSULT-II
    Front LH "YET" --> "DONE"
    Front RH
    Rear RH
    Rear LH
  8. Inflate all tires to proper pressure.
    1. Tire pressure 
    2. 16 inch tire: 240 kPa (2.4 kg/cm 2  , 35 psi) 
    3. 17 inch tire: 240 kPa (2.4 kg/cm 2  , 35 psi) 
scientia non olet · About LEMON Manuals