LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1057 (Rear Axle) >> Wheel Hub >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear wheel and tire using power tool.
  2. Remove the brake caliper assembly without disconnecting the hydraulic hose, using power tool.
    • The brake hose does not need to be disconnected from the brake caliper.
    • Suspend the caliper assembly using a wire so that the brake hose is not stretched.
      CAUTION:
      • Do not depress the brake pedal to prevent the caliper piston from popping out. 
      • Do not twist the brake hose. 
  3. Remove the brake rotor.
    NOTE: The parking brake must be fully released
  4. Remove the rear ABS sensor, then position it away from the hub assembly using wire.
    CAUTION:
    • Failure to remove the rear ABS sensor may result in damage to the sensor, causing the sensor to become inoperative. 
    • Do not stretch the rear ABS sensor wire harness. 
  5. Remove the wheel hub assembly from the knuckle using power tool.
scientia non olet · About LEMON Manuals