Cruise Test - Part 2

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK STARTING FROM D1
1. Move selector lever the "D" position.
2. Accelerate at half throttle.
With CONSULT-II

Read the gear position.

Does it start from D1?
1. Yes: GO TO 2.
2. No: Enter a check mark at "Vehicle cannot be started from D1" on the diagnostics worksheet, then continue the road test.
CHECK SHIFT-UP D1 --> D2
Press the accelerator pedal down all the way and inspect whether or not the transaxle shifts up (D1 --> D2) at the correct speed.
- Refer to Shift Schedule .
With CONSULT-II

Read the gear position, accelerator angle and vehicle speed.

Does the A/T shift-up D1 --> D2 at the correct speed?
1. Yes: GO TO 3.
2. No: Enter a check mark at "A/T does not shift D1 --> D2" on the diagnostics worksheet, then continue the road test.
CHECK SHIFT-UP D2 --> D3
Press the accelerator pedal down all the way and inspect whether or not the transaxle shifts up (D2 --> D3) at the correct speed.
- Refer to Shift Schedule .
With CONSULT-II

Read the gear position, accelerator angle and vehicle speed.

Does the A/T shift-up D2 --> D3 at the correct speed?
1. Yes: GO TO 4.
2. No: Enter a check mark at "A/T does not shift D2 --> D3" on the diagnostics worksheet, then continue the road test.
CHECK SHIFT-UP D3 --> D4 AND ENGINE BRAKE
When the transaxle change speed D2 --> D3, return the accelerator pedal.

Does the A/T shift-up D3 --> D4 and apply the engine brake?
1. Yes:
  1. Stop the vehicle.
  2. Go to Cruise test - Part 3 (Refer to Cruise Test - Part 3 ).
2. No: Enter a check mark at "A/T does not shift D3 --> D4" on the diagnostics worksheet, then continue the road test.