With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch "ON". (Do not start engine.)

Fig 1: CONSULT-II Display - Select System
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-II
Start engine.
Depress accelerator pedal or drive vehicle and maintain the following condition for at least 20 consecutive seconds.
TURBINE REV: More than 800 RPM
If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".