LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1056 (Automatic Transaxle Overhaul & Diagnostics) >> Re5F22A >> DTC P0825 Lever Switch Circuit >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "ON". (Do not start engine.)
    Fig 1: CONSULT-II Display - Select System
    G00746007Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-II.
  3. Set overdrive control switch to "OFF" position.
  4. Wait for at least 30 consecutive seconds.
  5. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals