LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1052 (Engine Control System) >> DTC P0037, P0038, P0057, P0058 Ho2S2: Heater >> DTC Confirmation Procedure >> Testing Condition: >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Start the engine and keep the engine speed between 3,500 RPM and 4,000 RPM for at least 1 minute under no load.
  5. Let engine idle for 1 minute.
  6. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  .
    Fig 1: Displaying Data Monitor
    G00775290Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals