LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1051 (Engine Cooling System) >> Thermostat And Thermostat Housing >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain coolant.
    CAUTION: Perform when engine is cool.
  2. Remove IPDM E/R bolts and position aside. Refer to REMOVAL AND INSTALLATION OF IPDM E/R .
  3. Disconnect lower radiator hose.
  4. Disconnect oil cooler line.
  5. Remove engine coolant inlet and thermostat assembly.
    • Do not disassemble engine coolant inlet and thermostat assembly. Replace them as a unit, if necessary.
      Fig 1: Removing Engine Coolant Inlet And Thermostat Assembly
      G00775151Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals