Removal Of Liquid Gasket

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

After removing the mounting bolts and nuts, disconnect and remove the sealant using a seal cutter.

CAUTION: Be careful not to damage the mating surfaces.

In areas where the cutter is difficult to use, use a plastic hammer to lightly tap the liquid gasket applied area.

CAUTION: If for some unavoidable reason a tool such as a flat-blade screwdriver is used, be careful not to damage the mating surfaces.

Fig 1: Using Seal Cutter

Courtesy of NISSAN MOTOR CO., U.S.A.