Hazard Warning Lamps Do Not Operate But Turn Signal Lamps Operate

Check that bulb standard of each turn signal lamp is correct.

OK or NG 

1. OK : GO TO 2.
2. NG : Replace turn signal lamp bulb.

Select "BCM" on CONSULT-II. Use "FLASHER" data monitor to verify that "HAZARD SW" turns ON-OFF linked with operation of hazard switch.

OK or NG 

1. OK : Replace BCM.
2. NG : GO TO 3.

Fig 1: Displaying Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Turn ignition switch OFF.
2. Disconnect BCM connector and hazard switch connectors.
3. Check continuity between BCM harness connector M3 terminal 61(G/R) and hazard switch connector M153 terminal 1(PU).
   1. Continuity should exist 

OK or NG 

1. OK : GO TO 4.
2. NG : Repair harness or connector.

Fig 2: Checking Continuity Between BCM Harness Connector Terminal And Hazard Switch Connector Terminal

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Connect BCM connector.
2. Check voltage between BCM harness connector and ground.

Fig 3: Terminal Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Checking Voltage Between BCM Harness Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK : GO TO 5.
2. NG : Replace BCM.

Fig 5: Terminal Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 6: Checking Continuity Between Hazard Switch Harness Connector

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK : GO TO 6.
2. NG : Replace hazard switch.

Check continuity between hazard switch harness connector M153 terminal 2(B) and ground.

1. Continuity should exist 

OK or NG 

1. OK : Replace BCM.
2. NG : Repair or replace harness.