LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> 350Z Standard >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> NVIS (NISSAN Vehicle Immobilizer System - NATS) >> NVIS (NISSAN Vehicle Immobilizer System-NATS) >> ECM Re-Communicating Function

ECM Re-Communicating Function

Performing following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one (*1).

*1: New one means a virgin ECM which has never been energized on-board.

(In this step, initialization procedure by CONSULT-II is not necessary).

NOTE:
  • When registering new Key IDs or replacing the ECM other than brand new, refer to CONSULT-II Operation Manual NATS-IVIS/NVIS.
  • If multiple keys are attached to the key holder, separate them before work.
  • Distinguish keys with unregistered key ID from those with registered ID.
  1. Install ECM.
  2. Using a registered key (*2), turn ignition switch to "ON".

    *2: To perform this step, use the key (except for card plate key) that has been used before performing ECM replacement.

  3. Maintain ignition switch in "ON" position for at least 5 seconds.
  4. Turn ignition switch to "OFF".
  5. Start engine.

    If engine can be started, procedure is completed.

    If engine cannot be started, refer to CONSULT-II Operation Manual NATS-IVIS/NVIS and initialize control unit.

scientia non olet · About LEMON Manuals