Consult-II Inspection Procedure

Turn ignition switch OFF.
Connect CONSULT-II to data link connector.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Insert NVIS (NATS) program card into CONSULT-II.
Program card: NATS (AENOOA)

Fig 2: Displaying CONSULT-II Main Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Touch START.
Select NATS V.5.0.

Fig 3: Displaying CONSULT-II NATS Version Selection Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic test mode according to each service procedure.

Fig 4: Displaying CONSULT-II Diagnosis Mode Selection Screen
Courtesy of NISSAN MOTOR CO., U.S.A.

For further information, see the CONSULT-II OPERATION MANUAL IVIS/NVIS .