Clearance Specifications

Whenever valve clearances are adjusted to cold specifications, check that the clearances satisfy hot specifications and adjust again if necessary

Intake	For Adjusting	Hot	0.32 - 0.40 Millimeter (mm)
		Cold At a temperature of approximately 20 deg C	0.25 - 0.33 Millimeter (mm)
	For Checking	Hot	0.21 - 0.49 Millimeter (mm)
Exhaust	For Adjusting	Hot	0.37 - 0.45 Millimeter (mm)
		Cold At a temperature of approximately 20 deg C	0.32 - 0.40 Millimeter (mm)
	For Checking	Hot	0.30 - 0.58 Millimeter (mm)
Stem To Guide Clearance	Intake		0.020 - 0.050 Millimeter (mm)