Actuator

ABS CONTROL ACTUATOR





1. Disconnect battery cable.
2. Drain brake fluid.
3. Discharge air conditioner refrigerant.





4. Disconnect all connectors from ABS relay unit.





5. Remove ABS relay unit with bracket.
6. Remove air conditioner low-pressure tubes.
7. Disconnect and separate brake lines and move away from control actuator.
It is not necessary to remove these lines from vehicle.
8. Remove ABS actuator.

CAUTION:
- After installation, pay attention to the following points: Apply soapy water to rubber bushing when installing.
- Refill brake fluid and bleed air. Brake Bleeding

- Charge air conditioner with refrigerant.
- The installation procedure is the reverse of removal.