Steering System Servicing Precautions

NOTE:

- Before disassembly, thoroughly clean the outside of the unit.

- Disassembly should be done in a clean work area. It is important to prevent the internal parts from becoming contaminated by dirt or other foreign matter.

- Place disassembled parts in order, on a parts rack, for easier and proper assembly.

- Use nylon cloths or paper towels to clean the parts; common shop rags can leave lint that might interfere with their operation.

- Before inspection or reassembly, carefully clean all parts with a general purpose, non-flammable solvent.

- Before assembly, apply a coat of Automatic Transmission Fluid (ATF) type Dexron III, or equivalent, to hydraulic parts. Petroleum jelly may be applied to O-rings and seals. Do not use any grease.

- Replace all gaskets, seals and O-rings. Avoid damaging O-rings, seals and gaskets during installation. Perform functional tests whenever designated.