Canister Purge Solenoid: Testing and Inspection

COMPONENT INSPECTION
EVAP Canister Purge Control Solenoid Valve










With CONSULT
1. Jack up driving wheels (M/T models only).
2. Turn ignition switch "ON".
3. Select "PURG CONT S/V" of "ACTIVE TEST" mode with CONSULT.
4. Start engine and warm it up to normal operating temperature.
5. Disconnect vacuum hose at EVAP canister purge control valve.
6. Touch "ON" and "OFF" and check for vacuum passing through the hose.

OR







Without CONSULT
Check air passage continuity.
If NG, replace solenoid valve.