Checking Fluid Leakage

Check Procedure
^ Check the lines for improper attachment, leaks, cracks, damage, chafing or deterioration.

1. Run engine between idle speed and 1000 RPM.
^ Make sure fluid temperature in reservoir tank rises to 60 - 80° C (140 - 176° F).
2. Turn steering wheel right-to-left several times.
3. Hold steering wheel at each lock position for five seconds and carefully check for fluid leakage.

CAUTION: Do not hold the steering wheel in a locked position for more than 15 seconds.





4. If fluid leakage at any line is noticed, loosen flare nut and then retighten or tighten hose clamps.

CAUTION: Do not overtighten flare nut as this can damage O-ring, washer and threads.

5. Check rack boots for accumulation of power steering fluid.