Actuator

1. Disconnect battery cable.
2. Drain brake fluid.
3. Discharge air conditioner refrigerant. Refer to Heating and Air Conditioning.





4. Disconnect all connectors from ABS relay unit.





5. Remove ABS relay unit with bracket.
6. Remove air conditioner low-pressure tubes.
7. Disconnect and separate brake lines and move away from control actuator.

NOTE: It is not necessary to remove these lines from vehicle.

8. Remove ABS actuator.
9. Reverse procedure to install, noting the following:
- Apply soapy water to rubber bushing when installing.
- Refill brake fluid and bleed air. Refer to Check and Adjustment and Brake Bleeding.
- Charge air conditioner with refrigerant.