LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1998 >> 200SX SE-R, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Brake Rotor >> Installation

Front Brake Rotor: Installation

  1. To install, reverse removal procedure. Coat wheel bearings and inside hub with wheel bearing grease. Install new inner grease seal.
  2. Tighten hub-to-rotor bolts evenly, and adjust wheel bearings. Tighten wheel bearing lock nut. Bleed hydraulic system. See BLEEDING BRAKE SYSTEM .


  1. Install and tighten hub-to-rotor bolts. Install wheel hub and knuckle in reverse order of removal. Pack cavity of knuckle with wheel bearing grease, and coat all bearings.
  2. Rotate hub to seat bearings. Tighten wheel bearing lock nut. Bend lock washer lip up into a lock nut groove. Install spindle assembly, and tighten suspension components. Ensure axle shaft end play is.004-.012" (.10-.30 mm).
  3. Adjust axle shaft end play with proper thickness snap ring. Mount and tighten caliper bolts. Bleed hydraulic system. See BLEEDING BRAKE SYSTEM .
scientia non olet · About LEMON Manuals