Low and Reverse Brake

DIMENSIONS
Driven Plate And Transmission Case Clearance:
Standard Value 1.4 - 1.8 mm (0.055 - 0.071 inch)
Wear Limit 2.8 mm (0.110 inch)
Thickness Of Drive Plate:
Standard Value 2.0 mm (0.079 inch)
Wear Limit 1.8 mm (0.071 inch)
Thickness Of Retaining Plates Part No. and Thickness:
31667-31x10 3.6 mm (0.142 inch)
31667-31x11 3.8 mm (0.150 inch)
31667-31x12 4.0 mm (0.157 inch)
31667-31x13 4.2 mm (0.165 inch)
31667-31x14 4.4 mm (0.173 inch)
31667-31x15 4.6 mm (0.181 inch)

GENERAL
No. Of Drive Plates 5
No. Of Driven Plates 5

TIGHTENING SPECIFICATIONS
Brake Band:
Anchor End Pin 3.9 - 5.9 Nm (35 - 52 inch lbs.)
Anchor Lock Nut 31 - 36 Nm (23 - 27 ft. lbs.)
No. Of Turning Revolutions For Anchor End Pin 2.375 - 2.625